Elektron Monomachine Instrukcja Użytkownika Pobierz pdf (Strona 21)

QUICK START

3. Choose to active a track using the [

TRACK] keys. Below is a screen shot of how the

SYNTHESIS page could look like after selecting a track.

4. Press a [

TRIG] key to add a note trig. A note trig is indicated by a red <TRIG> LED.

Pressing the same [TRIG] key once more removes the note trig.

5. To change the pitch of a note, press and hold the [TRIG] key. You will see a mini key-

board pop up in the lower left corner of the screen. Either input the new note on the key-

board or use the [ARROW] keys to select the new note. When done release the [TRIG]

key.

6. To enter a note off trig, press a [TRIG] key while holding the [FUNCTION] key. A Note

Off is indicated by a yellow <TRIG> LED. To remove a note off the same [TRIG] key

must be pressed twice.

OVERVIEW OF LIVE RECORDING MODE

The LIVE RECORDING mode allows you to record notes in real-time while the pattern is

playing.

To enter this mode, press and hold [RECORD] and then [PLAY].You can now play notes

on the track you want to record, using either the [TRIG] or a keyboard. All played notes will

be quantised to the closest trig step.

If a note is played on a position where there already was a note programmed the new note

will replace the note on that step.

To erase notes in LIVE RECORDING mode hold [EXIT/NO] while the notes you want to

remove are heard.

The pattern will loop and be ready for further recording until you press the [STOP] key.

PARAMETER LOCKS

A parameter lock is a parameter locked to a certain value for a specific step. Parameter

locks can be programmed in GRID RECORDING mode and recorded in LIVE RECORD-

ING mode. Parameter locks are a very important part of creating unique and dynamic pat-

terns.

To lock parameters on a specific step in the track in GRID RECORDING mode, hold a

[TRIG] key and turn or click a DATA ENTRY knob. The parameter connected to the knob

will be inverted to indicate that it now is has a parameter lock. The corresponding <TRIG>

LED will flash rapidly to indicate that a parameter is locked for that step.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 157 158

Brak uwag

Elektron Monomachine Instrukcja Użytkownika Strona 21