Elektron Machinedrum Instrukcja Użytkownika Pobierz pdf (Strona 51)

THE PATTERN SEQUENCER

2. When you are in the track you wish to clear, press a

nd hold [SCALE SETUP]. Then

press [PLAY] to clear the track. The message “CLEAR PAGE” will appear.

• The clear track page operation can be undone by holding the [SCALE KEY] and

pressing the [PLAY] key directly after the clear operation. The message “UNDO

PAGE” will be shown in the display.

PATTERN COPY

To copy the contents of a a pattern to another, follow the steps below.

1. Make sure you are not in GRID RECORDING mode, indicated by the <RECORD> LED

being unlit.

2. Select the source pattern. Hold [FUNCTION] while pressing [RECORD]. A message

“COPY PATTERN” will be shown in the display.

3. Change pattern to the destination where you wish to paste your pattern data by using the

[BANK] and [TRIG] keys.

4. Paste the data by pressing and holding [

FUNCTION] and then pressing the [STOP] key.

The message “PASTE PATTERN” will be shown in the display.

• The pattern data that is copied consists of notes, the kit association (in

EXTENDED mode) and parameter locks.

• Pasting a pattern overwrites any previous notes, data and parameter locks.

• The copy pattern operation will copy the whole pattern including unsaved kit

changes.

• You can undo the paste operation by holding the [FUNCTION] key and pressing

the [STOP] key.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 125 126

Brak uwag

Elektron Machinedrum Instrukcja Użytkownika Strona 51